How to fix a broken defroster tab

Here's a project that came out of my Prepare for Wintertime video. I plant that my Rear Defroster wasn't working. Upon farther inspection, I found that the tab that connects the wire to the window had broken off. After researching the best way to reattach it, I found this cool 2 in ane kit from Permatex. This kit is swell for me because after I repair this tab, I demand to set up a few grid lines on our other vehicle. Stay tuned for that video too.

The first step in this repair was for me to wait until we had a really nice twenty-four hours. The instructions say that the temperature should be in a higher place 50 degrees. That doesn't come very often here this fourth dimension of yr, so at the first sign of a warm solar day I was out getting information technology done. Of course if you have a garage and some way get a little heat in information technology, this shouldn't exist a problem. I starting time began by taking the sandpaper included in the kit, and cleaning off the metallic tab and very lightly cleaning the reattachment indicate on the window. At present, using the booze cleaning pad I cleaned the tab and window surface. I was very careful not to bear upon these later on wiping them off with the alcohol. At present I can carefully open up the activator pad and using the foil pack every bit the handle, I can wipe the activator on the window. Do not wipe the activator on the tab. One time the activator has been applied, you lot accept to expect for it to sit down for at least two minutes, but not more than than 15. Now take hold of the little adhesive pack, and brainstorm mixing it by kneading it in your fingers. It should become an even beige color. After kneading it for a couple minutes, cut open the pack and squeeze out some on the surface of the tab. The instructions say to add together one drib, but mine came out really fast and I know I had a lot on there. It still worked out. At present, carefully stick the tab in place on the window, and hold information technology firmly for one infinitesimal. After the tab is attached, you MUST let it cure for 24 hours earlier turning on the defroster. I didn't even reconnect the wire until the next solar day.

The next day, I brought out the multimeter and checked for continuity between the ii tabs on the window. This was good. Adjacent I turned on the defroster and immediately felt the window heating up. Using a test light, I tested for voltage at the tab and it was 12volts. Perfect. The repair is a success.

This footling kit worked out great. I am happy to take the defroster back up and running.

Cheque Out the Video of the procedure.

https://youtu.be/MhvJcXl3fGU

— Affilliate Links to Recommended Products —
Permatex Complete Rear Defroster Repair Kit – https://amzn.to/2PgO3G2
Permatex Tab Adhesive merely – https://amzn.to/33NwhiJ
Lisle Test Low-cal – https://amzn.to/33RlT9T
Fluke Multimeter (newer than mine) – https://amzn.to/34YST0U

Rockler